{% if keyword is not empty %} {{ keyword }} {% else %} Produkte von {{ manufacturer.translated.name ?? manufacturer.name }} {% endif %}
{% endif %}
{% set manufacturer = cbaxModulManufacturers.manufacturer ?? null %}
{% if manufacturer %}
{% set keyword = manufacturer.translated.customFields.cbaxManufacturerMetaKeyword ?? null %}
Hose nozzle and long thread 1/2" with seal and nut. For ø 10/12 mm connection.
This folding canister is made of PE polyethylene approved for food. Elastic, light blue, with cap and screw-on spout, spiral hose, 200 mm with end piece.
Inset sinks are the easiest way to retrofit a washbasin. Depending on the substructure, you cut a board to size (plastic or wood), saw an appropriate opening into it and insert the inset sink. Seal it ... done. The fittings are placed on the base plate. This way, you can retrofit any washbasin. Drain: ø 35 mm.
Is attached to the designated bottom opening of fresh and waste water tanks and used for "winterisation" (emptying) of the residual water.
Thanks to the integrated funnel, water can be safely filled into almost all water containers. Connection nozzles ø 40 mm are lockable. Incl. inner frame, installation template and screws.
Hose nozzle on one side, long thread 1/2" on one side, with seal and nut. For ø 10/12 mm connection.
Inset sinks are the easiest way to retrofit a washbasin. Depending on the substructure, you cut a board to size (plastic or wood), saw an appropriate opening into it and insert the inset sink. Seal it ... done. The fittings are placed on the base plate. This way, you can retrofit any washbasin. Drain: ø 35 mm.
Straight with outer thread. For ø 10/12 mm connection.
Variants from €2.90*
Lockable hatch in white, ideal for wall thicknesses of up to 25 mm. Equipped with winter insulation, it provides efficient protection against the cold and increases energy efficiency.
Inset sinks are the easiest way to retrofit a washbasin. Depending on the substructure, you cut a board to size (plastic or wood), saw an appropriate opening into it and insert the inset sink. Seal it ... done. The fittings are placed on the base plate. This way, you can retrofit any washbasin. Drain: ø 35 mm.