No cut-out necessary because of flat design. Ideal for retrofitting. Clear glass design; recessed; screw fastening. Equipped with 28 LEDs.
LED single-function vehicle lighting with 15 Highlight SMD LEDs.
No cut-out necessary because of flat design. Ideal for retrofitting. Clear glass design; recessed; screw fastening. Equipped with 28 LEDs.
Reliably replace your defective ATC LED control light on the AL-KO stabiliser system. With 400 mm cable and connector.
LED single-function lights with stainless steel frame.
Variants from €27.95*
LED side marker lights SMLR 2010c with integrated reflector. Connection cable 200 mm.
BBSWN 561: Indicator – Brake – Rear – Reversing – Fog Light
LED single-function lights with stainless steel frame.
LED single-function vehicle lighting with 15 Highlight SMD LEDs.
Side marker lights with completely homogeneous light-emitting surfaces give this new type of light a distinctive appearance. With a cable length of 300 mm. For Fendt Caravan and Adria Mobil.
Additional front illumination for attachment at inclined surfaces, for 23° inclines. Without bulbs (C5W).
LED single-function lights with stainless steel frame.
LED marker light white. Type: PL 24-2, 12 V
LED marker light red. Type: S 24-2, 12 V
Variants from €19.95*
The number plate light K 575 12 V is universally applicable and ideal for retrofitting or upgrading. It replaces the incandescent bulb number plate light K 570 (Jokon 13.4008.100) without additional electronics and can be swapped plug & play. Suitable, among others, for Fendt.
With illuminant, without reflector. For Adria, KNAUS, Bürstner and Chateau.
For horizontal installation with reflector incl. seal and 12 V bulb (W5W).
LED side marker lights SMLR 2010c with integrated reflector. Connection cable 200 mm.
LED single-function vehicle lighting with 15 Highlight SMD LEDs.
Indicator – brake – tail light for multi-purpose trailers. Can be installed either on the left or right-hand side. With the choice of number plate features.
Indicator – brake – tail and fog lamp with rear reflector and premounted bulbs.
With the hazard lights easydriver flashlight, your caravan is illuminated. While shunting in the dark, e.g. on the street in front of your garage or house entrance, a caravan without lights is hard to see. Easydriver flashlight draws attention to the caravan for other road users via hazard lights and outline markers.Safer manoeuvring with easydriver flashlight.Upgrade now!Safer manoeuvring due to greater visibility in the darkHazard lights and outline markers (can be switched on/off individually or at the same time)Power supply via the manoeuvring aid battery or an individual energy sourceEasy to retrofitAlso suitable for manoeuvring aids with safety outletScope of delivery: easydriver flashlight electronics box with two switches, cable harness, 13-pin socket, mounting material, mounting instructions
BBSN 561: Indicator – Brake – Rear – Fog Light
For horizontal installation in motorhomes. With 12 V bulbs.
Left – Indicator – Brake – Rear – Fog Light
Right – Indicator – Brake – Rear – Reversing
Variants from €107.95*
For vertical mounting with grey base plate. With 5 W light bulb.
glass socket (W 5 W) preinstalled. Suitable for KNAUS, Tabbert, various Italian manufacturers.
Dual-function bulb with 2 filaments.
Variants from €1.05*
For horizontal installation, for motorhomes. With 12 V bulbs.Left – Indicator – Brake – Rear – Fog LightRight – Indicator – Brake – Rear – Reversing
For horizontal installation in caravans. With 12 V bulbs.
Left – Indicator – Brake – Rear – Fog Light
Right – Indicator – Brake – Rear – Reversing
Horizontal or vertical installation. Yellow, with 12 V bulb. Base plate made of white plastic (for concealing wavy exterior walls e.g. caravans).
Standard car bulb in various designs. Suitable for your vehicle.
Variants from €0.85*
Vehicles wider than 2100 mm must be equipped with side marker lights. Front white, rear red.
The additional brake lights are equipped with 11 LEDs. Clear glass design, screw fixing, connection cable 250 mm (for various Italian manufacturers).
Can be used for vehicle lights with 95 mm diameter incl. indicator control box. Each light is equipped with 15 Highlight SMD LED lights. Protection class: IP67.The kit consists of:Rear fog lightReversing light2 indicator lights2 stop and tail lamps2 LED control boxes for checking the indicators
Light for integrated installation in plastic bumper; sphere lamp, suitable for left and right. Function: rear – brake – indicator – fog – reversing.
Light with 4 chambers. Functions: brake light, indicator, rear light and number plate light (optional), without bulb, for bike carriers and trailers.
Light for integrated installation in plastic bumper; sphere lamp, suitable for left and right. Function: rear – brake – indicator – fog.